Werbung
ELECTROMAGNETIC COMPATIBILITY
This product needs special precautions regarding electromagnetic compatibility and needs to be installed and put into service according to the chapter
"Electromagnetic compatibility".
Certain types of mobile telecommunication equipment could potentially interfere with this product. The separation distances recommended in the chapter
"Electromagnetic compatibility" must be taken into account.
In case of electrostatic discharge or mains interferences during the treatment, the miniEndo could momentarily lose its ultrasound intensity. In this case,
the pedal must be released and pressed again to recover the adjusted power.
This product should not be used adjacent to or stacked with other unit. If adjacent or stacked use is necessary, this product should be observed to verify
normal operation in the configuration in which it will be used.
The use of accessories and cables other than those specified or sold by SybronEndo as replacement parts, may result in increased emissions or de-
creased immunity of this product.
Electromagnetic emissions
The product "miniEndo" is intended for use in the electromagnetic environment specified below. The customer or the user of the product should assure
that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonics emissions
IEC 61000-3-2
Voltage fluctuations / flicker
emissions
IEC 61000-3-3
54
54
FB-128_ed_2007-05_miniEndo.indd 54
Compliance
Electromagnetic environment - guidance
Group 1
The product uses RF energy only for its internal function. Therefore, its RF emissions are very low
and are not likely to cause any interference in nearby electronic equipment.
Class B
The product is suitable for use in all establishments, including domestic establishments and those
directly connected to the public low-voltage power supply network that supplies buildings used
for domestic purposes.
Class A
Complies
8/14/2015 12:36:23 PM
Werbung
