Getting Started; Preparing The Remote Control - Anker Nebula Capsule Bedienungsanleitung

EN

Getting Started

1. Placement
Place this device on a surface
front of the projection
projection surface
distance between this device and the projection
surface must be a mlnimum of 0.58 meters (23") and
a maximum of 3.08 meters (121") to get a projection
mage from 20 to 100 inches.
•It is unnecessary
projection surface.
projection mage With the built-in keystone
correction.
•The distance
projection surface determines the projection
image size.
projection image ranging from 40 to 80 inches
table, flat table in
surface. For best results, the
should be white and flat. The
6
to tilt it towards
You can correct
between the device and the
For the best result, set the
2.

Preparing the Remote Control

O) For first time use, remove the protective tab to
activate the remote control battery
@To replacethe battery,unlockandopenthe battery
compartment, insert a new battery positioning the
polarity (+/-) as indicated, and then close and lock the
battery compartment,
3. Get Started
(j) Fully charge the built-in battery before usingfor the
first time by using the provided cable and charger.
@HoldQ) for 2 secondsonthe projector to powe
@ Turn the devicetowards a suitable projection
surface or wall.
@ Rotate the focus by adjusting knob to get the best
focus.
the
@ For first time use, follow the on-screen instructions
the
to complete the basic settings.
To give your Nebula Capsule the fastest, safest
charge, use the supplied charger only.
EN
INPUT