AEG AUK1173L Benutzerinformation Seite 11

Set a lower temperature about 12 h prior
to defrosting.
It is normal for a thin layer of frost to form on
the freezer shelves and around the top
compartment. Defrost the freezer when the
frost layer reaches a thickness of about 3-5
mm.
1. Switch off and unplug the appliance.
2. Remove stored food.
3. Leave the door open and protect the floor
from the water.
4. Put a pot of warm water in the freezer
compartment in order to speed up the
defrosting.
5. Dry the interior after defrosting.
6. Switch on the appliance. Close the door.
7. Set the lowest temperature for at least 3
hbefore you put the food back into the
freezer compartment.
6.5 Cleaning the air channels
1. Remove the plinth (A), then the
ventilation grid (B).
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
The appliance does not operate.
C B A
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
2. Clean the ventilation grid.
3. Carefully pull the air deflector out (C),
checking that there is no water left from
the defrosting.
4. Clean the lower part of the appliance with
a vacuum cleaner.
6.6 Period of non-operation
When the appliance is not in use for long
period, take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent
unpleasant smells.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
ENGLISH 11