Wash Cycles - Scholtes LTE 14-H206 A+ Bedienungsanleitung

Wash cycles

For available OPTIONS please refer to the Table of options on the Start-up and use page.
EN
The number and type of wash cycles and options may vary depending on the dishwasher model.
Wash cycle selection
instructions
Environmentally-friendly wash
cycle with low energy
consumption levels, suitable for
pans and dishes.
Normally soiled pans and dishes.
Standard daily wash cycle.
Pre-wash for dishes while
awaiting completion of the load
with the dishes from the next
meal.
Heavily soiled dishes and pans
(not to be used for delicate
items).
Economic and fast wash to be
used for lightly soiled dishes.
(Run cycle immediately after use)
(2 plates + 2 glasses + 4 pieces
of cutlery + 1 saucepan + 1 small
frying pan).
Economic and fast wash for
delicate items which are sensitive
to high temperatures. (Run cycle
immediately after use) (glasses
upper rack+ delicate plates, lower
rack).
Notes:
Optimum performance levels when using the "Rapid wash" cycles, can be achieved by observing the maximum amounts
of crockery specified.
To make it easier to measure out the detergent, it is worth remembering that:
1 tablespoon = 15 grams of powder = approximately 15 ml of liquid - 1 teaspoon = 5 grams of powder = approximately 5
ml of liquid.
*
The Eco wash cycle adheres to the regulation EN-50242. Although it has a longer duration than other wash cycles it
uses less energy and is les harmful to the environment.
Note for Test Laboratories: for information relating to comparative EN testing conditions, please send an email to the
following address: ASSISTENZA_EN_LVS@indesitcompany.com
20
(A) = compartment A
Wash cycle
(B) = compartment B
Powder
29 g (A) 29 ml (A)
6 g (B) 6 ml (B)
*
1. Eco
29 g (A) 29 ml (A)
6 g (B) 6 ml (B)
2. Normal
No
3. Soak
35 g (A) 35 ml (A)
4. Super Wash
25 g (A) 25 ml (A)
5. Rapid
35 g (A) 35 ml (A)
6. Crystal
Detergent Wash
Cycles
which
include
Liquid Tablets
drying
1 (A) Yes
1 (A) Yes
No No No
1 (A) Yes
1 (A) No
1 (A) Yes
Wash cycle
duration
Options
(tolerance
±10%)
Hrs. Min.
A–B-C 2:55'
A–B–C 1:50'
A–B 0:08'
A–B–C 2:25'
A - C 0:25'
A–B–C 1:30'