Diagnostics - Elco Remocon Plus 2 Technische Anweisungen

User Menu
– "Units of measure and costs":
– "Currency": the parameter sets the currency shown
in the consumption charts.
– "Gas Type": selects the type of gas used to calculate
the gas consumption estimates.
– "Gas units": selects the unit of measurement used
for gas consumption estimates.
– "Gas cost": sets the price for the unit of measure-
ment used to calculate gas consumption estimates.
– "Electric units": selects the unit of measurement for
power consumption estimates.
– "Electricity cost": sets the price for the unit of meas-
urement used to calculate power consumption
estimates.
Units of measure and costs
Currency
Gas Type
Gas units
Gas cost
Electric units
Electricity cost
SCOP
Shows the estimate of the seasonal COP estimate of the heat
pump (only for configured devices).
SEER
Shows the estimate of the seasonal EER estimate of the heat
pump (only for configured devices).
CO2 SAVED
Shows the estimate of the kilograms of CO
thermal production of the solar heating system.
SHOWERS N°
Shows the estimate of remaining showers (if a solar heating
controller or a DHW heat pump is installed).
REPORT RESET
Resets the data appearing in the system performance pages.

Diagnostics

Diagnostics
The diagnostics page shows the main operating parameters
of the devices present in the system.
Euro (€)
Boiler
NG
kWh
0 cent
kWh
0 cent
Fig. 56
saved with the
2
Boiler
Energy Manager
Heat Pump TDM
Solar Controller
CH flow set T
CH flow temperature
CH return temperature
>
>
>
>
Fig. 57
55°C
20°C
20°C
Fig. 58
45 / EN