Herunterladen Diese Seite drucken

LD Systems ANNY 8 Bedienungsanleitung Seite 5

Vorschau ausblenden Andere Handbücher für ANNY 8:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 36
ATTENTION:
1. Do not operate the device if it has been exposed to large temperature fluctuations (for
example after transport). Moisture and condensation can damage the device. Switch on
the device only when it has reached ambient temperature.
2. Make sure that the voltage and frequency of the mains correspond to the values specified
on the device. If the device has a voltage selector switch, do not turn the device on until it
has been set correctly. Use only suitable mains cables.
3. To disconnect the device from the mains on all poles, it is not sufficient to press the on/
off switch on the device.
4. Make sure that the fuse used corresponds to the type specified on the device.
5. Make sure that appropriate measures have been taken against power surges (for examp-
le lightning strike).
6. Observe the specified maximum output current on devices with Power Out connection.
Ensure that the total current consumption of all connected devices does not exceed the
specified value.
7. Replace pluggable mains cables only with original cables.
8. Connect the device only to compliant, tested, and undamaged
mains supply devices.
DANGER:
1. Danger of suffocation/choking! Plastic bags and small parts must be kept out of reach of
children and persons with limited physical, sensory, or mental abilities.
2. Danger caused by falling device! Make sure that the device is securely installed and
cannot fall down. Only use suitable stands or mounts (particularly for fixed installations).
Ensure that accessories are properly installed and secured. Ensure that all applicable
safety regulations are observed.
WARNING:
1. Use the device in the prescribed manner only.
2. Operate the device only with the accessories recommended and intended by the manu-
facturer.
3. During installation, observe the safety regulations applicable in your country.
4. After connecting the device, check all cable routes to avoid damage or accidents, for
example due to tripping hazards.
5. Always observe the specified minimum distance to normally flammable materials! Unless
explicitly stated, the minimum distance is 0.3 m.
CAUTION:
1. Moving components such as mounting brackets or other movable components may
become jammed.
5

Werbung

loading