MAXXMEE 09640 Bedienungsanleitung Seite 12

EN
prevent the device from working and
to avoid possible damage.
■
Do not use any corrosive or abrasive
cleaning agents to clean the device.
USE
Please Note!
■
The device must have clearance of at
least 30 cm above it and to all sides
and be placed on a dry, even and
solid surface.
■
Make sure that the HEPA13 filter is
fitted correctly before using it.
■
Only connect the mains adapter to
a plug socket that is properly installed
and matches the technical data of
the mains adapter. The plug socket
must also be readily accessible after
connection so that the connection to
the mains can quickly be isolated.
■
Do not operate the device unsuper-
vised so that you can intervene imme-
diately if there are any faults.
1. Fully unwind the USB cable and con-
nect it to the connecting socket of the
device.
2. Connect the USB cable to a plug
socket via a mains adapter.
3. Position the device at the location you
want.
L
For efficient operation we recom-
mend closing the windows and
doors of the room.
4. Touch the On / Off button (5) to switch
on the device.
Setting ventilation levels:
Touch the button (1) –
The control lamps light up
constantly. The ventilation level
which is set is indicated by the
control lamps. The ventilation
12
09640_Inlay_DE-EN-FR-NL_A5_V1.indb 12 09640_Inlay_DE-EN-FR-NL_A5_V1.indb 12
level changes when you touch
the button again.
Setting the timer:
Touch the button (2) –
The control lamps light up con-
stantly. The time which is set
(1 / 2 / 4 / 8 hours) is indicated
by the control lamps. Another
time is selected when you touch
the button again.
5. If the device is no longer going to be
used, touch the On / Off button to
switch off the device. Then disconnect
the USB cable from the device.
CLEANING AND STORAGE
Please Note!
■
The HEPA13 filter cannot and must
not be cleaned.
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
• Make sure that the device is not con-
nected to the mains power.
• Wipe down the device with a soft,
damp cloth if necessary.
• Store the device in a clean, dry place
which is protected from dust and is
out of the reach of children and ani-
mals when it is not in use.
MAINTENANCE
The device must be kept ready to oper-
ate, which means the HEPA13 filter must
be replaced when used regularly (roughly
every 3 – 6 months). The precise intervals
at which the HEPA13 filter has to be re-
placed depend on the air quality and the
frequency of use of the device.
02.11.2022 15:58:44 02.11.2022 15:58:44