Reflexion LED22iBT Bedienungsanleitung Seite 87

PAIRING THE SMARTPHONE WITH THE TV
5. A numerical code is now displayed on the TV. Enter this in the input field of your Apple device and click
on "OK".
6. The devices are now paired and the picture from your Apple device is displayed on the TV set.
SIMPLE TROUBLESHOOTING
If the screen fails or there is a sharp drop in performance, check the TV using the following instructions: Also
check connected devices to find the source of the fault. If the screen still does not work as expected, contact
customer support.
1. No power

Check that the mains adapter or the car adapter is connected to the TV set.

Check that the toggle switch is in the on position.
2. No picture or no sound

Check whether the mains adapter or the car adapter is connected to the TV set.

Check the picture and sound settings.

Check whether the antenna / cable system / satellite antenna is connected correctly.

Change to another programme.

Check that the connected devices (e.g. receiver) are connected correctly.
3. Poor picture quality

Check that the antenna cable is connected correctly.

Check the manual TV tuning of the TV channel.

Change the picture settings: Brightness, colour, sharpness, contrast and hue. Make sure that the TV is
not located near other electrical appliances that could cause radio frequency interference.
4. No colour

Adjust the colour settings.

Check that the selected programme is broadcast in colour.

Make sure that the channel is tuned correctly.
5. The TV does not respond to the remote control

Make sure there are no obstacles between the remote control and the TV.

Make sure the remote control is within reach.

Make sure that the batteries in the remote control are not dead.
6. No voice input and no motion control possible with the Magic remote control
To pair the remote control again if the motion control or voice input does not work, pair the remote control
with the TV set again.

Press and hold the Home button and Back button for approx. 5 seconds until the Power button on the
remote control flashes three times. A message appears on the TV screen that the connection has been
disconnected.

Now press the OK button to pair the remote control with the TV set. A message appears on the TV
screen indicating that the remote control is connected to the TV set again.
7. No Internet content will be played back

Check in the network settings whether the TV set is connected to your router.

Check the settings of your router.
This TV is intended for household use and is classified as harmless with regard to electromagnetic waves.
Therefore, you can use the unit in any location, including residential areas.
87
UK