Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Set the heating temperature between 120-150°C based on the melting point of the hot melt glue. Once the
glue reaches its melting point, the Glue-melting Tank automatically switches to heat-preservation mode,
and the moving engine starts running, indicating the machine is ready to apply the tape. The heating
element is controlled by a thermostat. Even when the moving engine stops, the Glue-melting Tank
continues heating or maintaining the set temperature.
3. If you need to stop the machine, press the EMERGENCY STOP button on top of the handle to stop the
moving engine, while the heating element remains on. Alternatively, press the main switch to turn off the
entire machine.
4. When banding small wood pieces, secure the machine to the working table using the provided fixing
blanket. Push the wood piece at the machine's running speed. (As shown in the picture.)
5. When banding large wood pieces, secure the wood piece on the working table using the provided
absorber. Hold the machine by hand to apply the banding. (As shown in the picture.)
NOTICE
•
Before operation, ensure the wood piece's edge is even, clean, and free of dirt or dust.
Check that the tape is smooth and flexible.
•
Before using the machine to band with a new tape, adjust the glue thickness by
turning the knob according to the tape's thickness after the moving engine starts.
•
Adjust the High Limiter to match the tape width, ensuring smooth application without
EN
Werbung
