Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the tape shifting up or down.
Maintenance
•
Keep the machine body clean. Use gasoline or a specialized cleaner for hot melt glue to clean the
blanket, press tape wheel, tape-sending wheel, and High Limiter.
•
Clean out residual hot melt glue from the Glue-melting Tank every 50 working hours before adding new
glue. To clean: power on the machine, heat the Glue-melting Tank, and turn off the engine. Once the
glue has softened, use a wooden spoon to remove the remaining glue from the tank. (Ensure you wear
heat-resistant gloves to avoid burns.)
Troubleshooting
If any issues arise with the machine, they should be addressed as follows:
1. If the indicating light is not on after switching on the machine:
•
Check the power supply and ensure the power cable is firmly connected.
•
Check if the fuse needs to be replaced.
2. If glue on the tape is too thin, insufficient, or uneven:
•
If the banding tape is too hard or unbendable, it may not press closely to the gluing wheel.
•
Adjust the pressure on the tape using the Press Tape Wheel.
•
Ensure the glue in the Glue-melting Tank is fully melted and at least 1/3 full.
•
Check for glue buildup between the Glue-melting Tank and the gluing wheel surface.
•
Verify that the hot melt glue and banding tape meet the specifications and replace them if
necessary.
3. If the machine cannot heat up or the temperature displays incorrectly:
•
Power off the machine and open it.
•
Inspect whether the heating pipe, temperature control meters, or probe need replacement.
4. If the engine does not run:
•
Check if the hot melt glue temperature has reached the preset level.
•
Ensure the temperature display is functioning properly.
•
Verify if the Engine Starting Button is working properly or if it is loose.
•
Have a Licensed Engineer inspect whether the engine or other electrical parts need repair or
replacement.
Disposing of Used Devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device recycling
and collection point. Check the symbol on the product, instruction manual and packaging. The plastics used to
construct the device can be recycled in accordance with their markings. By choosing to recycle you are making a
significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
Parts
EN
Werbung
