Product Description; Environmental Protection; Cleaning And Maintenance - Concept Rk 7010 Bedienungsanleitung

EN

PRODUCT DESCRIPTION

1. Lid
2. Switch button
3. Kettle handle
4. Kettle body
5. Operating light
6. Lower electric section
7. Plastic cup
8. Supply cable
9. A textile bag
9
CAUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then
pouring it out. The kettle is then ready for operation.
NOTE! The product is convenient for mobile use and camping purposes. It is not designed for ordinary use.
OPERATING INSTRUCTIONS
1. Open the kettle and fill it with cold water. Do not exceed the maximum level! If the water level exceeds the
recommended maximum, the kettle will overheat, which may cause destruction of the heater.
2. Place the kettle on a stable level surface, close the lid properly and connect the supply cable to power
socket.
3. Push the switch button lightly, the operating light goes on and the kettle starts heating. Do not open the
lid during heating – risk of scalding.
4. The kettle turns off as soon as the water boils and the operating light turns off.
5. Do not switch the kettle on repeatedly before it cools down. The switch button is blocked until the kettle
cools down. Pushing the switch with excessive force may cause damage to thermostat.
6. After using, unplug the cable from the power supply.

CLEANING AND MAINTENANCE

WARNING!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
Make sure the appliance has cooled down before handling it.
Only use a wet cloth for cleaning the surface; never use detergents or hard objects, as they may damage it.
Never clean the unit under running water; do not rinse it or submerge in water.
32
1
4
7
6
Limescale removal
Impurities from water build up during normal use. These sediments can be removed
perfectly from the kettle using preparations designed for removing limescale
2
(observe the producer's instructions) or using the following procedure:
1. Pour 100 ml of vinegar and 100 ml of water into a kettle and bring to the boil.
3
2. Pour out the contents, and clean the remaining sediment using a wet cloth. Fill
the kettle with clean water, boil it and pour it out again. Repeat the procedure
once more. The kettle is then ready for continuing operation.
Note: Remove the sediment inside the kettle regularly, about once a week,
depending on the water hardness and frequency of use. Deposits reduce the
5 heating effect and the service life of the kettle considerably.
SERVICING
8
Any extensive maintenance or repair requiring access to the internal parts of the product shall be performed
by an authorized service center.

ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical and electronic equipment - WEEE). The
symbol on the product or on its packaging indicates that this product may not be treated as
household waste. Instead it should be taken to the appropriate collection point for the
recycling of electrical and electronic equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of this
product. The disposal of such material has to be done according to the recycling regulations.
For more detailed information about recycling of this product, please contact your local
council, your household waste disposal service or the shop where you purchased the appliance.
The product meets all the necessary requirements of the EU directives applicable to the
specific product.
Changes in text, design, and technical specifications are subject to change without prior notice and we
reserve the right to change them.
EN
33