Sublue WHITESHARK MIX Bedienungsanleitung Seite 9

Operating Instructions
Preparations before usage
Before use, fully charge the battery with a dedicated charger. If all the five
Indicators are on, the battery is full;
If the battery is secured correctly, buckling sound can be heard;
(as shown in the following diagram)
Before Installation
Check whether the product shell is damaged. If yes, do not use it;
Press the two start buttons in the air (no more than one minute) for testing.
Ensure the thrusters and indicators are in good condition without jamming
or noise;
In order to prevent loss, an safety leash is provided during deep diving. Pay
attention to the surroundings to prevent entanglement;
After above inspection, it can be put into use. In case of any problem,
please stop using immediately.
Install The
Giving Off
Battery
Buckling Sound
After Installation
-11-
Installation of the floater.
(optional)
Align the hanger of the floater(①) with the hanger of the WHITESHARK MIX
body (②); (as shown below)
Insert screws (③) (no need to tighten but only insert); (as shown above)
Press the floater down toward WHITESHARK MIX to make the suction cups
on the floater (④) attach to the WHITESHARK MIX;
Tighten screws (⑤) to complete assembly of the floater .
(as shown above)
(as shown below)
-12-