Beyerdynamic MMX 300 PRO Bedienungsanleitung Seite 5

How to connect the headset to a game console
In contrast to a PC, game consoles only have one mini
jack connection (3 .5 mm) .
� Connect the supplied adapter and the cable to your
game console as illustrated .
Optionally, you can purchase a 1 .2 m long console
�
cable (order # 918105) with a mini jack plug (3 .5 mm) .
Putting on the headset
Put the headset on your head . The microphone is on
�
the left-hand side .
� Position the microphone in front of the middle of your
mouth . In order to avoid pop noise, you should use
the microphone with a pop shield .
Adjusting the headband
To optimise the wearing comfort, adjust the head-
�
band of the headset to your head via the adjustable
yokes on the left and right side of the housing shells .
� Wear the headset so that the headband runs over
the centre of your head and adjust the headband
so that
your ears are completely enclosed by the ear pads,
�
you feel a gentle pressure around your ears,
�
both ends of the headband have the same length .
�
Adjusting the microphone
Turn the microphone holder (never the gooseneck!)
�
to position the microphone as requested .
Make sure that the pop shield completely encloses
�
the microphone .
MMX 300 PRO — Gaming Headset
� Bend the flexible gooseneck so that the microphone is
placed about two centimetres in front of your mouth .
In order to avoid overstretching and
premature wear and tear never bend the
gooseneck more than 90° .
Remote control
The connection cable has an integrated remote control
with a volume control and a mute switch . Use the
volume control to adjust the volume of the headset . Use
the mute switch to mute or activate the microphone .
Increase the volume:
� Turn the volume control upwards .
Reduce the volume:
Turn the volume control downwards .
�
Mute the microphone:
Slide the mute switch downwards
�
(red marking visible) .
Activate microphone:
Slide the mute switch upwards
�
(red marking not visible) .
Mute switch:
Microphone
muted
Volume control
MAINTENANCE
As with any equipment which will be used near
�
sensitive areas of the body, it is essential that the
ear pads and headband are kept clean .
Use a soft cloth moistened with water for cleaning .
Make sure that no water drops into the ear cups or
transducers .
� If necessary, you can carefully remove the ear pads
and headband pad and clean them with mild soapy
water .
Never use any solvent cleaning agents!
Furthermore, the pads must be completely
dry before they are reattached to the
MMX 300 PRO .
Never use a vaccum cleaner for cleaning the
MMX 300 PRO, as this may cause irreparable
damage .
Should it become necessary to replace the ear pads
�
or the headband pad, refer to "Replacement parts
and Accessories" . You can easily do this yourself .
Refer to the chapters "How to change the ear pads"
and "How to change the headband pad" .
If other components must be replaced, please
�
contact your local beyerdynamic representative .
5
Mute switch:
Microphone
active
Volume control