Carat RG-1250 Betriebsanleitung Seite 19

6.2 Dust extraction
Always use a suitable dust extraction system:
Connect an M-class vacuum cleaner to the extractor
connection piece (12). For optimal dust extraction, use
the connecting sleeve 6.30796. We recommend using an
antistatic suction hose with diameter 35 mm.
7. ATTACHING THE ACCESSORY
Disconnect the mains plug before changing any accesso-
ries. The machine must be switched off and the spindle
must be at a standstill.
7.1 Locking the spindle
Press in the spindle locking knob (11) only when the
spindle is stationary!
- Press in the spindle locking button (11) and turn the
spindle (9) by hand until you feel the spindle locking button
engage.
7.2 Fitting/removing the diamond cup wheel
See illustration B on page 2.
To fit:
• Fit the support flange (8) on the spindle. (9) The flange
should not turn on the spindle when properly attached.
• Lay the diamond cup wheel (7) on the support flange (8)
so that it lies flat along the support flange.
• The two sides of the clamping nut (6) are different.
Screw the clamping nut onto the spindle so that the
band of the clamping nut (6) is facing upward.
• Lock the spindle (see chapter 7.1). Turn the clamping
nut (6) clockwise using the 2-hole spanner (5) to secure.
To remove:
- Lock the spindle (see chapter 7.1). Turn the clamping nut
(6) anticlockwise using the 2-hole spanner (5) to unscrew.
8. USE
8.1 Working close to walls
To open and close the segment: switch off the ma-
chine and pull the mains plug. The accessory
must be stationary.
Only raise the segment (13) when working close to
walls. Otherwise, the segment must be lowered.
The open area of the safety guard must face the direction
of the wall.
8.2 Setting the speed
Set the optimum speed on the setting wheel (16),depend-
ing on the application. A wheel setting of between 4 and 6 is
suitable for most applications.
8.3 Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the accessory towards
the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When switching the
machine on and off, keep it away from dust deposits. After
switching off the machine, only set it down when the motor
has come to a standstill.
Avoid inadvertent starts: always switch the tool
off when the plug is removed from the mains
socket or if there has been a power cut.
In continuous operation, the machine continues
running if it is forced out of your hands. Therefore,
always hold the machine with both hands using the han-
dles provided, stand in a safe position and concentrate on
the work.
Machines with the designation W...RT:
Torque activation (with dead man's lever)
Switching on: Slide the trigger switch (17) forwards and
then push the trigger switch (17) upwards.
Switching off: Release the trigger switch (17).
Machines with the designation W...RT:
Continuous operation (depending on features)
Switching on: Switch the machine on as described above.
Now slide the trigger switch (17) forwards again and release
in the front position to lock the trigger switch (17)(continuous
operation).
Switching off: Push the trigger switch (17) upwards and
release.
8.4 Working Directions
Surface grinding:
Place the machine with the entire surface of the tool onto the
workpiece. Apply moderate pressure and move it to and fro
across the surface.
19