Atlas Copco C8-06 Sicherheitshinweise Seite 4

Safety Information
Authorised Representative EU
Håkan Andersson, Managing Director
Atlas Copco Industrial Technique AB
SE-105 23
Stockholm, SWEDEN
UK DECLARATION OF INCORPORATION
We, Tentec Ltd. C/O Atlas Copco Bolt Tightening Solu-
tions Unit F1, Innovation Drive, Pendeford, Wolverhamp-
ton, England, WV9 5GA, declare under our sole responsibil-
ity that this product (with name, type and serial number, see
front page) fulfils the following essential requirements of The
Supply of Machinery (Safety) Regulations 2008 S.I.
2008/1597:
S.I. 2008/1597 (Annex 1 Clause: 1.1, 1.3, 1.5, 1.6, 1.7)
And that this partly completed machinery is in conformity
with the provisions of the following other UK Regulations:
S.I. 2016/1105
This partly completed machinery must not be put into service
until the final machinery into which it is to be incorporated
has been declared in conformity with provisions of The Sup-
ply of Machinery (Safety) Regulations 2008 S.I. 2008/1597,
where appropriate.
The following (parts/clauses of) Designated Standards have
been applied:
The relevant technical documentation was compiled and was
communicated in accordance with The Supply of Machinery
(Safety) Regulations 2008 S.I. 2008/1597 part B of Annex
VII. Authorities can request the technical file in electronic
form from:
Jonathan Gibbs, Quality Manager
Atlas Copco Bolt Tightening Solutions
Unit F1, Innovation Drive, Pendeford
Wolverhampton. England. WV9 5GA
Wolverhampton, 14 August 2024
Nicholas Evans, General Manager
Signature of issuer
Safety
DO NOT DISCARD - GIVE TO USER
4 © Atlas Copco Industrial Technique AB - 9846 0623 00
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
Product Specific Instructions
Operation
Operation Safety
WARNING High-Pressure Fluids Hazard
Never grab, touch, or in any way come in contact with a
hydraulic pressure leak. When the hydraulic circuit is
pressurized, the hydraulic fluid can escape at high speed.
Escaping fluid under pressure can penetrate the skin
causing serious injury. If an accident occurs, contact the
nearest health service immediately! Any fluid injected
into the skin must be surgically removed within a few
hours or gangrene may result.
Always relieve pressure before disconnecting hy-
►
draulic or other lines. Tighten all connections before
applying pressure.
Always wear safety approved eye wear when check-
►
ing for leaks. Do not use your hands to check for
leaks in the hydraulic circuit.
Always keep away from leaking elements during the
►
tightening process.
Always wear impact-resistant eye and face protec-
►
tion when involved with or near the operation, repair
or maintenance of the unit.
Be sure all others in the area are wearing impact-re-
►
sistant eye and face protection.
Even small projectiles can injure eyes and cause
►
blindness.
C8-06