Werbung
Während des Regenerierens kann es zu einer Ge-
3.
ruchsentwicklung kommen. Um sicherzustellen,
dass der Raum gut belüftet ist, ein Fenster öffnen.
Den regenerierbaren Geruchsfilter mit den folgen-
4.
den Einstellungen regenerieren.
Dauer
Temperatur
120 min
max. 200 °C
Den heißen Geruchsfilter auf einer hitzebeständi-
5.
gen Unterlage abkühlen lassen.
Geruchsfilter säubern
ACHTUNG!
Falsche Reinigung beschädigt den regenerierbaren
Geruchsfilter.
Regenerierungshinweise beachten.
▶
Nie einen regenerierbaren Geruchsfilter mit Reini-
▶
gern, mit Wasser, in der Geschirrspülmaschine
oder mit einem nassen Tuch reinigen.
Wenn am regenerierbaren Geruchsfilter Ver-
▶
schmutzungen sichtbar sind, die Verschmutzun-
gen vor der Regenerierung mit einem feuchten
Tuch entfernen.
Darauf achten, dass der Geruchsfilter nicht nass
wird.
en
Scope of delivery
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
→ Fig.
1
General information
Read this instruction manual carefully.
¡
Keep the instruction manual and the
¡
product information safe for future refer-
ence or for the next owner.
The appliance can only be used safely if it
¡
is correctly installed according to the
safety instructions. The installer is re-
sponsible for ensuring that the appliance
works perfectly at its installation location.
This instruction manual is intended for the
¡
installer of the optional accessory.
Only a licensed expert may connect the
¡
appliance.
Switch off the power supply before carry-
¡
ing out any work.
Safe installation
Observe the safety instructions when installing the
optional accessory.
WARNING ‒ Risk of suffocation!
Children may put packaging material over their
heads or wrap themselves up in it and suffocate.
Keep packaging material away from children.
▶
Do not let children play with packaging material.
▶
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
The odour filter remains hot for quite some time after
it has been regenerated.
Do not touch the odour filter straight after it has
▶
been regenerated – allow it to cool down.
A non-regenerable odour filter may catch fire in the
oven.
▶
ATTENTION!
Heizart
If a regenerable odour filter falls, it may become
Umluft
damaged. The damage is not always visible from the
outside.
▶
Regenerable odour filter
Odour filters bind odorous substances in circulating-
air mode. Regularly replaced or regenerated odour
filters guarantee a high level of odour removal.
With normal use (daily for approx. one hour), replace
the odour filter at least every 10 years.
The regenerable odour filter can be regenerated in a
standard oven.
With normal use (approx. 1 hour a day), the regener-
able odour filter must be replaced or regenerated
every 3-4 months. The regenerable odour filter can
be regenerated up to 30 times.
Removing the odour filter
1.
2.
Regenerating the odour filter
The oven cleaning function (pyrolytic self-clean) may
cause a regenerable odour filter to catch fire.
▶
The odour filter remains hot for quite some time after
it has been regenerated.
▶
Note: During the regeneration process, parts of the
odour filter may become discoloured. This discolour-
ation has no effect on the performance of the odour
filter.
Requirement: The odour filter is removed.
1.
2.
3.
4.
5.
WARNING ‒ Risk of fire!
Only regenerable odour filters that can be regen-
erated.
Dispose of and replace any regenerable odour fil-
ters that have fallen.
Remove the panel.
→ Fig.
2
Note: Be aware that the odour filter is heavy.
Take hold of the odour filter in one hand from be-
low and remove it.
→ Fig.
3
WARNING ‒ Risk of fire!
Never regenerate a regenerable odour filter with
the oven cleaning function (pyrolytic self-clean).
WARNING ‒ Risk of injury!
Do not touch the odour filter straight after it has
been regenerated – allow it to cool down.
Preheat the oven to a maximum of 200 °C (air re-
circulation ).
To ensure that you do not scratch the baking tray,
place the odour filter on a wire rack.
During regeneration, an odour may develop. Open
a window to ensure that the room is well ventil-
ated.
Regenerate the regenerative odour filter with the
following settings.
Duration
Temperature
120 mins
Max. 200 °C
Leave the hot odour filter to cool down on a heat-
resistant surface.
Type of heat-
ing
Air recircula-
tion
3
Werbung
