Herunterladen Inhalt Inhalt Diese Seite drucken

Venga VG RVC 3000 Bedienungsanleitung Seite 14

Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
TROUBLESHOOTING
Your venga robot will tell you when something is wrong with a two-tone distress sound . The
indicator will also blink or light up in red. Refer to the chart below to resolve the robot's
problem.
For some errors, rebooting the robot may resolve the problem. To reboot the robot, press
the power button on the bottom on robot. You will hear an audible tone signifying a
successful reboot.
ROBOT BLINKS AND
INDICATES
BEEP Once
BEEP Twice
Solid red
indicator
light
BEEP Triple
BEEP Four
Times
BEEP Twice
BEEP Triple
Breathing
red
indicator
light
BEEP Four
Times
Note : Anti-drop sensors prevent the Robot Vacuum from tumbling downstairs and steep
drops. They may work less effectively if dirty or used on reflective/very dark-colored floors.
Also, anti-drop sensors can be triggered by strong sunlight area. If it causes the robot to
move in an unusual pattern, please use the curtains to block sunlight from entering in the
room or switch the robot on later, when the sun has moved away.
VG RVC 3000
LIKELY CAUSE
Front caster wheel is
stuck
Robot's side brush
probably stuck
Robot's vacuum fan is
stuck or its
filter is clogged.
Robot's rolling brush can't
turn.
Bumper is stuck.
Robot's cliff sensors are
dirty, it is hanging over a
drop edge , or it is stuck
on a dark surface.
Robot cannot return to its
Charging Dock or starting
position.
14
WHAT TO DO
Clean the front caster
wheel and press the power
button to restart the robot.
Clean the side brush and
press the power button to
restart the robot
Remove and empty robot's
bin. clean robot's filter. then,
briskly tap the bin to loosen
any remaining trapped
debris.
Remove and clean Robot's
rolling brush
and caps.
Check whether the bumper
is flexible
If robot is hanging over a
drop edge , or on a dark
surface, start in a new
location. Otherwise, wipe
its cliff sensors with a dry
cloth.
Ensure there are no
obstacles in front of the
charging dock or starting
position. Wipe the charging
contacts on both the
charging dock and robot
with a clean, dry cloth.
Inhaltsverzeichnis
loading

Inhaltsverzeichnis