Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Afterwards operate the switch connected with the
channel to be added (taught) to enter teach mode.
The device LED flashes orange. (Cancel by pressing
the teach button briefly, the device LED then turns
red.)
If no teaching occurs, teach mode is automatically
ended after 20 seconds. If other devices are in teach
mode, these are taught.
If learning is completed successfully, it is indicated
with the green LED (length of time depends on
whether it is still configuring).
Note:
If the switch interface is already taught for a
center and therefore is blocked for direct training, it
can still be put in configuration mode as described
above, the device LED is illuminated in red for 2
seconds after pressing a connected switch however.
Direct teaching is not possible!
30
Feedback messages of the device LED in
configuration mode:
Min. 2 sec. green LED
2 sec red LED
Device in configura-
tion mode and illumi-
nated red with switch
operation
8
Simple operating functions
After teaching, simple operating functions are
available.
The three channels are taught as three switches
(ON/OFF) on the receiver upon delivery. Switch
actuators can then be switched ON/OFF. The blind
actuators move up or down (Operation: UP/STOP/
DOWN/STOP).
You can also provide changeover connections by
using the switch interface.
Teaching successful
Teaching failed
Device already taught
for center and is
therefore blocked from
direct teaching
31
Werbung
Kapitel
Inhaltsverzeichnis
