Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
General information on radio
operation
The radio transmission is on a non-exclusive
transmission path which means that there is a
possibility of interference occurring.
Other interfering sources can be caused by
switching operations, electrical motors or defective
electrical devices.
The range of transmission within buildings
can greatly deviate from open air distances.
Besides the transmitting power and the reception
characteristics of the receiver, environmental
influences such as humidity in the vicinity and local
structures also play an important role.
Hereby eQ-3 Entwicklung GmbH, declares that this
device conforms with the essential requirements
and other relevant regulations of Directive1999/5/EC.
The full declaration of conformity is provided under
www.HomeMatic.com.
24
6
Installation
The switch interface has flexible connection lines
(0.75 mm
) with cable end sleeves. Remove the
2
rubber caps that are on the end sleeves before
connecting.
This allows connecting directly to the switches used
according to the following diagram.
If you do not use all channels, leave the
rubber caps on the cable end sleeves or the
unused channels.
Keep the maximum cable length of 3 m between
switch and switch interface.
The switch interface is only adapted for
connecting potential-free switches.
Do not connect the connection lines to mains
voltage!
25
Werbung
Kapitel
Inhaltsverzeichnis
