DTS511
1. Replaceable toothbrush head
2. On/Off switch
3. Power monitor diodes
CHARGING THE BATTERY
Make sure that the toothbrush is switched off before placing it on the charging unit.
Connect the charging unit (5) to the power supply. Place the toothbrush handle with
drive on the charging unit. The full charging process can last more than 17 hours. It is
recommended to store the toothbrush handle in the charging unit. The battery
contains a protecting circuit against overcharging.
After placing the toothbrush handle in the charging base, the indicator lights will
indicate the battery charge level. The more diodes lit, the more charged the battery is.
The green LED will flash while the battery is charging. When charging is completed, the
LEDs will turn off.
USING YOUR TOOTHBRUSH
1.
Use the replaceable toothbrush head (1) on the handle with a drive (4). Wet the
toothbrush with water and apply a small amount of toothpaste.
2.
Put the toothbrush in your mouth, on the teeth gently tilted toward the gums (as
shown in the Figure)
3.
Turn on your toothbrush with the switch button (2). You can change the brushing
mode by pressing the switch button immediately after switching on the
toothbrush.
4.
To improve the efficiency of teeth cleaning, the mouth should be divided into
four zones. Clean each zone for 30 seconds (the toothbrush signals with a
momentary break when each 30 seconds expires). The toothbrush will switch off
automatically after 2 minutes. To finish teeth cleaning earlier, turn off the
toothbrush with the switch button
5.
After switching the toothbrush off, remove the head (1) from the handle (4) and
thoroughly rinse both elements.
6.
Put the handle (4) onto the charging unit (5).
BRUSHING MODES
1.
CLEAN - standard brushing mode
2.
SOFT - gentle brushing mode
3.
MASSAGE - pulse mode to stimulate the gums
4.
WHITEN - brushing, whitening and polishing
5.
POLISH - polishing – intensive tooth polishing mode, brighter whitening
effect
CLEANING AND MAINTENANCE
Make sure that the charging unit is removed from the power supply before starting
cleaning.
Wipe the inside of the charging unit with a wet cloth and then dry.
It is recommended to replace the toothbrush heads every 3 months. Recommended
heads: BLAUPUNKT ACC024, ACC067
4. Handle with drive
5. Charging unit
4