Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Adding a new SITUO VARIATION io REMOTE CONTROL
Caution! For the SITUO 5 Variation A/M io, first select the
group (button i).
2.1 Select the Operating mode. The SITUO Variation io has
4 pre-programmed operating modes.
Mode 2: The variator is active and enables the user to vary
the intensity of the heating.
2.2. Unclip the battery cover.
2.3. Press the button (E) once, the LED will be switch to 1,
2, 3,4 successively, and set the remote control in the
operating Mode 2 (LED 2 lit) that is used to control and
vary the heating.
2.4. Clip the battery cover back on.
2.5. Press the button UP and DOWN simultaneously, until
the lamp is ON/OFF in one cycle.
2.6. Briefly press the PROG button: The lamp is ON/OFF
one time, to indicate that the SITUO Variation had been
paired with the heater.
To add or delete a SITUO Variation io (b) to or from a paired SITUO Variation (a).
Press the PROG button (a) (≈ 2 s) until the lamp is ON/OFF one time.
Briefly press the PROG button (b) consequently within 2 minutes.
3. Restoring the heater to the original configuration
Caution! This reset removes all paired remote controls (if missed or
defective) and adding a new remote control.
3.1. Switch the power off 2 seconds.
3.2. Switch the power on 10 seconds (more than 5 seconds and less
than 15 seconds)
3.3. Switch the power off 2 seconds.
3.4. Switch the power on. The lamp will be ON and OFF one cycle.
3.5. Press the button "PROG" uninterruptedly until the lamp is
ON/OFF in the first cycle, and the lamp is ON/OFF in the second
cycle, and then release the button "PROG".
3.6. Press the button UP and DOWN simultaneously until the lamp is
ON/OFF in one cycle.
3.7. Briefly press the PROG button on the new remote control, and
the lamp is ON/OFF one time, to indicate that all paired remote
controls are removed, and this new remote control is added.
18
Werbung
