Ronix RP-0100 Bedienungsanleitung Seite 25

TROUBLESHOOTING
Disconnect from the electrical power supply before carrying out user
maintenance or checking is correct functioning. To avoid unnecessary
disappointments, you should check the following before contacting the
service organization.
In case problems other than the above occur, please contact your local
distributor.
Symptom
Machine refuses to
start
Fluctuating pressure
Machine stops
Fuse blows
Cause
- Machine not plugged in
- Defective socket
- Fuse has blown
- Defective extension cord
- Pump sucking air
- Valve is dirty, worn out
or stuck
- Pump seals worn out
- Fuse has blown
- Incorrect mains voltage
- Thermal sensor
activated
- Nozzle partially blocked
Fuse too small
Recommended Action
- Plug in machine
- Try another socket
- Replace fuse
- Switch off other machine
- Try without the extension
cord
- Check that hoses and
connections are airtight
- Clean and replace or refer to
local distributor
- Clean and replace or refer to
local distributor
- Replace fuse
- Switch off other machines
- Check that the main voltage
corresponds to specification on
the model tag
- Leave the washer for 5
minutes to cool down
- Clean the nozzle
- Change to an installation
higher than the amp
consumption of the machine
- You may try without the
extension cord
User Manual
|
2 3