Ronix RP-0100 Bedienungsanleitung Seite 18

- Comply with the below-mentioned requirements for length and
cored dimensions.
1.0mm max. 12.5m
2
1.5mm max. 20m
2
2.5mm max. 30m
2
- Power cord connections should be kept dry and off the ground.
- If the power cord is damaged, it must be replaced by the manufacturer or
his service agent or similarly qualified person in order to avoid a hazard.
- All keep the machine on a stable and flat surface during operation,
handling, transportation and storage. Sudden overturn of machine will
cause injury to body.
- In the event of accident or breakdown, switch off the machine
immediately. (e.g. contact with detergent: rinse with an abundance of
clean water.
ATTENTION:
Through poor conditions of the electrical MAINS, shortly voltage drops
can appear when starting the EQUIPMENT. This can influence other
equipment (e.g. Blinking of a lamp). If the MAINS-IMPEDANCE Zmax <
0.335 OHM, such disturbances are not expected. (In case of need, you
may contact your local supply authority for further information.)
WARNING!
ELECTRICAL SHOCK HAZARD
Improper connection of the equipment – grounding conductor can result
in a risk of electrical shock. Check with a qualified electrician or service
person if you are unsure if an outlet is properly grounded. DO NOT
modify the plug provided with the appliance to fit an outlet, have a proper
outlet installed by a qualified electrician.
MAINS POWER CONNECTION
The following should be observed when connecting the high pressure
washer to the electric installation:
|
16
Induction Pressure Washer