Ronix RP-0100 Bedienungsanleitung Seite 21

WARNING!
The intake water temperature must not exceed 40. The water supply
must not exceed 0.7 MPa.
CAUTION:
The washer must only be used with clean water; use of unfiltered water
of corrosive chemicals will damage the washer.
- Push the motor switch to "OFF" position.
- Check that the electrical supply voltage and frequency (Volt/Hz)
correspond to those specified on the washer rating plate. If the power
supply if correct, you may now plug in the washer.
OPERATION
- Turn on the water supply tap fully.
|
1 9
User Manual