Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9
Let the cutting element and the clipping attachment
dry completely before you reassemble the
appliance.
Note: Make sure the electrical contacts of the clipping
attachment are dry before you reattach the attachment to
the handle.
10
To attach the clipping attachment, put it on the
handle in such a way that the open dot on the
handle is aligned with the arrow on the clipping
attachment (1). Then turn the clipping attachment
clockwise until the arrow is aligned with the solid
dot on the handle (2) (Fig. 16).
Replacement
If the adapter is damaged, always have it replaced with
one of the original type in order to avoid a hazard.
Only replace a damaged or worn attachment or comb
with an original Philips replacement attachment or comb.
Philips replacement parts (clipping attachment, cutting
element, combs, handle and adapter) are available from
your Philips dealer and authorised Philips service centres.
If you have any difficulties obtaining replacement parts for
the appliance, contact the Philips Consumer Care Centre
in your country (you find its phone number in the
worldwide guarantee leaflet).
Environment
-
Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment (Fig. 17).
-
The built-in rechargeable batteries contain substances
that may pollute the environment. Always remove
the batteries before you discard and hand in the
appliance at an official collection point. Dispose
of the batteries at an official collection point for
batteries. If you have trouble removing the batteries,
you can also take the appliance to a Philips service
centre. The staff of this centre will remove the
batteries for you and will dispose of them in an
environmentally safe way.
Removing the rechargeable batteries
Only remove the rechargeable batteries when they
are completely empty.
1
Disconnect the appliance from the mains and let
the appliance run until the motor stops.
2
Remove the comb from the appliance.
3
Remove the clipping attachment from the handle.
4
Use a screwdriver to remove the screw from the
handle (Fig. 18).
5
Separate the two handle parts with your
hands (Fig. 19).
6
Lift the batteries out of the appliance (Fig. 20).
7
Cut the wires close to the batteries with a pair of
household scissors (Fig. 21).
Do not connect the appliance to the mains again after
you have removed the batteries.
guarantee & service
If you need service or information or if you have a
problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care
Centre in your country (you find its phone number in
the worldwide guarantee leaflet). If there is no Consumer
Care Centre in your country, go to your local Philips
dealer.
4222.002.80001
3/9
Werbung
Inhaltsverzeichnis
