Inhaltsverzeichnis
Werbung
The electrical installation has to be done by an authorized electrical enterprise.
Please hand over this information and the wiring regulations, enclosed to each motor and switch or
control unit, to the responsible electrician.
SINGLE CONTROL-230V
(house-wiring)
Netz / circuit
230V, 50Hz
Antrieb
1
drive
blu
2
3
blk
4
M
brn
~
5
3x0,75 ²
Abzweigdose
connection box
Irregular wiring causes the destruction of the motor!
To avoid capacity overload and destruction of the micro-limit-switches in the motor, wiring
and controlling must be comply with the following instructions:
Overload causes shifted final positions. Contacts can weld together and the motor is powered permanently
and destroys the screen.
3.Switch period between UP- and DOWN commands must be 500ms at least.
Switching between UP and DOWN under 0,5 seconds effects in temporary extremly high current and causes
damaging of the limit switches and will lead to the destruction of the screen.
12
ELECTRICAL INSTALLATION
L1 N PE
Abzweigdose
connection box
STOP
CONTROLLING with MEDIA CONTROL PANEL:
Controlling a motor screen with a media control panel, you
have to install a motor control unit !
Any damage to the motor and any consequential damage
caused by not installing a motor control unit is not covered
by warranty.
motor control units - see chapter "Accessories"
1.Parallel connection of two or more motors on one
output is forbidden!
To control two motors with one switch , connections of each
motor and both running directions must be electrically sepa-
rated.
(see diagram on the left)
2.Switches and control system must not allow
simultaneous UP- and DOWN commands.
A simultaneous UP- and DOWN command causes a
short-circuit of the operating capacitor.
Therefore electrically or mechanically seperated
single-switches must be used only.
Do not use light switches!
(see diagram on the left)
Werbung
Inhaltsverzeichnis
