Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Safety Instructions - Sygonix 59412W1 Bedienungsanleitung

Dis farbkamera, 1000 tvl, 6 mm
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operating instructions
GB
DIS Colour Camera, 1000 TVL, 6 mm
Intended Use
This camera is intended for installation in, monitoring and protecting, se-
cluded or critical areas (e.g. entrance areas, surveillance of underground car
parks and the like).
The camera is only intended to be used with a stabilised direct current of
12 V/DC.
The product is designed for use indoors and outdoors (IP65).
Please bear in mind that it is prohibited by law to observe strangers with a
camera without their knowledge and consent. Observe the rules and regu-
lations of the country where you are using the camera.
The safety instructions must be observed at all times!
Any use other than that described above could lead to damage to this prod-
uct and involves the risk of short circuits, fire, electric shock, etc. No part of
the product may be modified or converted!
This product complies with the applicable national and European require-
ments. All names of companies and products are the trademarks of the
respective owners. All rights reserved.
Package contents
• Camera with pre-mounted wall bracket
• Allen key (for adjusting the wall bracket)
• 3x screws
• Operating instructions
Explanation of symbols
This symbol indicates specific risks associated with handling, func-
tion and use.
The "arrow" symbol indicates special tips and operating information.

Safety Instructions

The warranty will be void in the event of damage caused by
failure to observe these safety instructions! We do not assume
any liability for any resulting damage!
We shall not accept liability for damage to property or personal
injury caused by incorrect handling or non-compliance with the
safety instructions. In such cases, the warranty/guarantee will
be null and void.
• The unauthorised conversion and/or modification of the product
is not permitted for safety and approval reasons (CE). Never dis-
mantle the product.
• The camera is only intended to be used with a stabilised direct cur-
rent of 12 V/DC. The inner contact of the round low-voltage plug
should be Plus/+, the outer contact Minus/-.
• The product is not a toy and does not belong in the hands of chil-
dren. It should be operated out of the reach of children.
• The use of this camera does not replace the personal supervision
of children or people who require special assistance, but only
serves as a support for this supervision.
• The camera is suitable for use in indoor and outdoor areas (IP65).
However, it must never be used in or under water, as this will de-
stroy it.
The home technology brand for the entire house. More information at www.sygonix.com
The plugs on the camera's connection cable are not waterproof or
watertight and must therefore be placed in a dry indoor area.
• The camera should not be exposed to extreme temperatures, di-
rect sunlight, strong vibrations or heavy mechanical stress.
• Make sure that the connection cable is not pinched or damaged by
sharp edges.
• Do not leave packaging material carelessly lying around, since it
could become a dangerous plaything for children.
• Handle the product with care, it can be damaged by impacts,
blows, or accidental falls, even from a low height.
• If the camera is used with other devices (e.g. a monitor), the oper-
ating instructions and safety notes for these devices must also be
followed.
• Safe operation can no longer be assumed if:
- the device is visibly damaged,
- the device no longer works
- the device has been stored under adverse conditions for a long
time
- it was exposed to heavy loads during transport
• In commercial institutions, the accident prevention regulations of
the Employer's Liability Insurance Association for Electrical Sys-
tems and Operating Facilities are to be observed.
• If you have any questions that are not answered in this manual,
please contact our technical service or other specialist.

Installation

The camera should not be pointed directly towards bright sources of
light or the sun, since this will overexpose the image.
For outdoor use we recommend to choose a location that is pro-
tected from rain (e.g. under the eaves) to prevent the formation of
droplets on the camera's front panel that will cause a distorted and
unusable image.
The camera is equipped with a pre-mounted wall bracket. This is to be tight-
ened to a suitable place using three screws. Use dowels if required by the
surface.
Make sure when screwing into place or when drilling holes that no
cables or wires are damaged.
If the connection cable is to be laid so it is hidden, a correspondingly large
hole has to be drilled underneath the wall bracket, so the plug can be
passed through. The wall bracket will then cover this opening and protect
the cable from intentional damage.
Alternatively, the cable may be lead outward via a small opening on the side
of the wall mount. Protect the cable with a suitable cable conduit or similar.
The connection plugs are not waterproof and should be kept in-
doors, otherwise they could corrode.
To align the camera, loosen the two Allen head screws (one is situated at
the side of the wall bracket, the other at the bottom). You can use the cor-
responding Allen key provided.
Place the camera as desired and fasten it with the delivered Allen key.
You can accurately align the camera after start-up when the camera image
is displayed on a monitor.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis