Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BEFORE FIRST USE
• Remove all packaging material and any labels, transport protection stickers, etc. before first use.
Warnings and type plates must not be removed!
• Fully charge the battery before initial operation (see chapter „Charging the battery").
BATTERY CHARGING
• Only charge the battery with the supplied AC adapter.
• Do not cover the battery and AC adapter during charging.
• When charging, the battery may be inside the device or charged separately. The wall mount also acts
as a charging cradle, and the power cord can be connected directly to the wall mount. In this case, the
battery will charge whenever the unit is mounted in the wall bracket.
• Do not use the device while the battery is charging or while the power cord is connected to the
battery.
• Before first use, as well as after each complete discharge of the battery, it must be fully charged before
further use.
• Before inserting the battery into the device, check the contacts for cleanliness.
• If an error occurs during charging, disconnect the power immediately.
• Always connect the supplied power cord first to the battery or charging cradle (wall mount) and then
to a wall outlet.
• Never pull the plug by the cable from the charging socket or from the socket.
• When you charge the battery in the device, the charging status is indicated by LEDs on the back of the
handle unit.
24
Item Number : 3929 / 3932
ASSEMBLY
• Push the battery straight into the motor unit from below until it audibly clicks into place. Make sure
that the battery is not tilted or inserted the wrong way round. Make sure the battery is securely
engaged before connecting any other accessories to the main unit.
• The crevice nozzle or the 2 in 1 upholstery nozzle can be placed directly onto the suction opening.
Make sure that the nozzles are only pushed on hand-tight to avoid damage and injury.
• The electrical floor nozzle must be pushed straight onto the suction opening so that the electrical
connection can be made at the bottom of the nozzle with the main unit. The electric floor nozzle
audibly engages with the main unit.
• As an option, you can also use all nozzles with the extension suction pipe. Place the extension suction
pipe straight on the suction opening so that the electrical connection is established. The extension
suction pipe also audibly engages.
• If the extension suction pipe or the electric floor nozzle are to be separated from the main part, press
the respective unlocking button on the suction pipe or floor nozzle and remove the respective part
from the suction opening. The crevice nozzle and the 2 in 1 upholstery nozzle do not engage and can
therefore be easily removed from the respective suction opening.
• Replace all accessories only when the appliance is switched off!
25
Werbung
