Werbung
EN
If the device cannot be switched on,
the battery is too weak and needs to be
charged.
The device should preferably be charged
at a plug socket using a USB mains adapter
(not supplied with the device).
1. Plug the connector of the USB cable
into the USB socket (15) of the motor
unit (2).
2. Connect the USB cable to a USB mains
adapter and then connect this to a plug
socket.
The charging process begins and the
control lamp lights up red.
When the control lamp lights up blue,
the battery is charged.
3. Pull the USB mains adapter out of the
plug socket and then pull the USB cable
out of the device.
USE
Please Note!
■ Thoroughly rinse all accessories before
you first use them in order to remove
possible production residues. To do this,
follow the instructions in the "Cleaning
and Storage" chapter.
■ Inspect the device for damage each
time before you use it. Only use it if it
is undamaged and has been correctly
assembled!
• The blending attachment (1) is par-
ticularly suitable for puréeing soups,
sauces, dips, etc.
• The whisk (Picture D) is used to blend
liquid ingredients or beat egg white.
• The chopper (Picture E) is intended for
chopping vegetables, onions and nuts.
12
Preparing the blending attachment /
whisk
1. Place the food which is to be processed
in the measuring cup (3) which is sup-
plied or another suitable vessel.
PLEASE NOTE! Do not overfill the meas-
uring cup! Make sure that the maximum
fill level (top mark on the scale) is not
exceeded.
2. Plug the attachment you want (blend-
ing attachment or whisk) on the motor
unit (2) and twist it until it clicks into
place.
3. Hold the attachment in the vessel with
the food which is to be processed.
Preparing the chopper
1. Plug the blade insert (6) onto the axis
in the middle of the container (9).
2. Place food in the container.
3. Put the lid (5) on. It must rest on the
container without any gap.
4. Plug the motor unit (2) into the lid and
twist it clockwise until it clicks into place.
Operating the device
L
When using the blending attach-
ment, hold it as straight as possible,
not at an angle, to prevent splashing!
1. To switch on the device, press and hold
the
button (13) until the control lamp
lights up blue. Then press the
ton (14) within 10 seconds and hold
it down.
The accessory rotates while the
button is pressed.
PLEASE NOTE! The
be pressed while the control lamp is lit
up blue.
• To change the speed level, turn the
speed regulator (11).
2. To switch off the device, let go of the
button.
but-
button can only
Werbung
