Cautions And Warnings - Xylem Flojet R2830 Serie Installations- Und Bedienungsanleitung

INSTALLATION & OPERATION
City water IN
or draw from tank
prime up to 8 feet
120°F (49°C)
Safe Water
Operating
Temperature
ON/OFF
Valve
34°F (1.1°C)
Flojet Pressure
Regulator
01752-XXXX
(not included)
Make connections
using stepless
or suitable hose
clamps
1. Install the booster and power supply indoors, in an area
protected from splash, spillage, or soiling.
2. Install service valves (not included) before and after the system
as required to create a system bypass loop.
3. Note: For incoming water supply line install a 30 psi (2.1 bar)
Flojet pressure regulator PN#01752-XXXX (not included with
all models). Failure to do so may void warranty.
4. Adjust precharge pressure on accumulator tank to label
specified pressure using air or nitrogen only. Failure to do so
may void warranty.
WARNING: Do not use CO
pre-charge. CO
2
components can create a hazardous chemical
reaction.
5. Connect inlet and outlet fittings to suitably rated hose using
stainless stepless clamps.
6. Turn on incoming water. Plug in the system and open outlet
valves and purge air from the system.
7. Inspect systems and installation for leaks and proper function.
8. Periodically check accumulator pre-charge and re-pressurize as
required to proper setting. See system label.
Accumulator
Inline strainer
for accumulator
2
mixed with water and brass
Tank
Pump
Filtration

Cautions and Warnings

WARNING − RISK OF AN ELECTRICAL SHOCK!
When wiring an electrically driven pump, follow all
electrical and safety codes, as well as the most recent
National Electrical Code (NEC) and the Occupational
Safety and Health Act (OSHA). Install in a GFCI protected
outlet for maximum protection. Disconnect power before
servicing the unit.
For use with water only. Do not pump flammable
liquids. Do not use in a flammable environment.
EXPLOSION HAZARD: Do not use for pumping flamma-
ble liquids with flash point below 100°F (37.8°C). Doing
so may result in explosion which could cause personal
injury, death or property damage.
CAUTION: Pressurized System; release pressure from
accumulator tank and system prior to servicing.
WARNING: Do not use CO
CO
2
hazardous chemical reaction.
WARNING: After any "Water Boil Warning or Water
boil Advisory" is lifted, be sure to completely flush and
sanitize your system (Refer to Maintenance & Sanitation
section for further instructions).
Remove and replace the bladder in the tank or replace the
tank as needed.
Test water as necessary to be sure contaminants are no
longer present.
Regulate incoming water pressure to 30 psi (2 bar) max.
Tank must be pre-charged with air to 50-60 psi (3.4-4 bar).
WARNING: Do not use pump if it presents some damage
such as burned or broken pressure switch, broken port
clips (if applicable), exposed electrical wire and/or
contacts.
NOTICE: END OF LIFE PRODUCT DISPOSAL
Handle and dispose of all waste in compliance with local
laws and regulations.
4
Flojet Pressure
Regulator
01752-XXXX
(optional)
Install just prior
to equipment for
pressure control
Water out to
carbonator
and/or non-carb
(still water)
dispensing
valves
for accumulator precharge.
2
mixed with water and brass components can create a
Dispenser