LEMI NEXT Bedienungsanleitung Seite 6

The power supply must be supplied to the unit by a line:
Protected against overcurrent by an automatic circuit breaker (circuit breaker) or fuses, properly sized; the ope-
rating current of the protections must be as low as possible taking into consideration the maximum absorption
of the device;
Equipped with a device sensitive to insulation failure (differential) with operating current low enough; this device
must be positioned downstream of the overcurrent protective device (or be integrated with it);
Having cables with section suitable for the power absorbed by the appliance.
2.7. Connections
START (ON): plug the power cable into a suitable electric socket. If there is incompatibility between the
outlet and the plug of the table, ask qualified personnel to replace it with a suitable one.
STOP (OFF): Remove the plug from the electric socket.
ATTENTION! Pull out by grabbing THE PLUG, NOT THE CORD
WARNING! It is strongly recommended to insert the plug into a single outlet exclusively reserved
to the device. We do not recommend the use of multiple sockets (power strip), adopters and patch
cords. The cable must not be bent.
WARNING! Before plugging in the cable, make sure that it is not twisted or bended and make sure
that the protective sheath is undamaged.
WARNING! The table must be positioned in order to ease the removal of the electric plug.
WARNING! To avoid the risk of electrical shock, this table must exclusively be plugged in power
supply grids with protective ground.
3. ENVIRONMENTAL WORKING CONDITIONS AND STORAGE
The table has been designed and built to operate in a closed and dry room. The ambient operating condition are:
• temperature: 5° ÷ 40° C
• humidity: 30% ÷ 75% without condensation.
If the environmental conditions are particularly critical it is advisable to provide the room with an adequate air condi-
tioning system to bring the humidity and temperature values within acceptable limits.
WARNING! Do not expose the table to an excessively humid environment. If the table gets wet, re-
move the plug from the outlet and have it checked by an Authorized Service Centre.
WARNING! The table was not conceived to be used in settings with explosive atmospheres, in pre-
sence of thin powders or corrosive gases, acids, corrosive agents or salt. Neither it is recommended
to use the table in presence of ionizing and not ionizing radiations (x rays, lasers, microwaves, ultra-
violet rays).
- Not intended to be used in oxygen rich environments.
- Not intended to be used with flammable anesthetics or in conjunction with flammable agents.
6
To avoid the risk of electric shock, this appliance must only be connected to a power supply
with protective earth (grounding).
%