Care And Maintenance - Ribimex Rx6 Bedienungsanleitung

OPERATION WITH DETERGENT
Detergent can only be added when the device is operated in
low pressure mode.
! DANGER
When using detergents, the material data safety sheet
issued by the detergent manufacturer must be adhered,
especially the instructions regarding personal protective
equipment.
Remove the cap of the clean detergent bottle. Gently pull
the onboard detergent tank out of its storage position.
Fill the tank with detergent designed specifically for use with
pressure washers.
Push the detergent bottle with the opening pointing
downwards into the connection for the hose clean
detergent.
RECOMMENDED CLEANING METHOD
• Spray the detergent sparingly on the dry surface and allow
it to react, but not to dry.
• Spray off loosened dirt with the high pressure Met.
AFTER OPERATION WITH DETERGENT
• Remove the hose clean detergent bottle from the intake
and close it with the lid.
• For storage, put the detergent bottle into the retainer with
the cap pointing up.
NTERRUPTING OPERATION
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
• Put the trigger gun with the spray lance into the parking
position.
• During longer breaks(more than 5 minutes), also turn the
appliance off using the "OFF/ON" switch.
FINISH OPERATION
• Release the lever of the trigger gun.
• Turn off the appliance " OFF/ON" switch.
• Disconnect the mains plug from the socket.
•Separate the high-pressure hose from the trigger gun or
the device when there is no pressure in the system.
• Pressure the lever of the trigger gun to release any
remaining pressure in the system.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
ATTENTION
• When disconnecting the supply or high pressure hose,
warm water may leak from the connection after operation.
• Detach the appliance from the water supply.
TRANSPORTATION
CAUTION
!
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
WHEN TRANSPORTING BY HAND
• Switch the product off and disconnect it from the water and
power supply.
• Pull out the transport handle until it audibly snaps into
place. Attach transportation guards, if applicable.
• Pull the appliance by its transport handle.
STORAGE
CAUTION
!
Risk of personal injury or damage!
Consider the weight of the appliance when storing
it.
STORING THE APPLIANCE
• Park the machine on an even surface.
• Detach spray lance from the trigger gun.
• Push the disconnect button on the trigger gun and pull the
high-pressure hose out of the trigger gun.
• Place the trigger gun into the storage for the trigger gun.
• Put both spray lances into the storage for the spray lance.
• Dirt grinder spray lance: Nozzle towards the bottom.
• Coil the high-pressure hose and hang it over the hose
storage.
• Store the mains connection in the accessory compartment.
• Prior to extended storage periods, as during the winter,
also observe the instructions in the care section.
• Always store the pressure cleaner, parts, and accessories
in a place that is inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C. Store the power
washer indoors to prevent the water in the unit from
expanding under freezing conditions.
• We recommend using the original package for storage or
covering the product with a suitable cloth or enclosure to
protect it against dust.
FROST PROTECTION
ATTENTION
Appliance and accessories that are not completely drained
can be destroyed by frost.
Completely drain appliance and accessories and protect
them against frost. To avoid damage:
• Detach the appliance from the water supply.
• Detach spray lance from the trigger gun.
• Turn on the appliance "ON/OFF" switch.
• Push the lever of the trigger gun until no more water is
escaping.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
• Turn off the appliance "ON/OFF" switch.
• Store the appliance and the entire accessories in a frost
free room.

CARE AND MAINTENANCE

DANGER
!
Risk of electric shock
Prior to all work on the appliance, switch off the
appliance and pull the power plug.
HIGH PRESSURE HOSE
The high pressure hose is specially constructed with
reinforced walls it can be easily damaged and should be
stored carefully.
• Do not kink.
• Do not drive vehicles over the hose.
• Do not expose the hose to sharp edges or corners. Misuse
will lead to ballooning or premature failure and will invalidate
warranty.
CLEAN THE SIEVE IN THE WATER CONNECTION
Clean the sieve in the water connection regularly.
Remove coupling from the water connection, and rinse with