Ribimex RX6 Bedienungsanleitung Seite 16

2. Connect the high-pressure hose to the trigger gun
3. Connect the high-pressure hose to the water outlet
4. Connect the garden hose to the water inlet
Connect the garden hose adaptor (female coupler) to the
water inlet of the pressure washer, then thread your garden
hose(male end) into the garden hose adaptor.
5. Slide the trigger gun holder into position of unit left
5.1. Slide the power cord hook into position of unit right
5
6. Installing the high pressure hose reel with four
screws.
Only for PRNHP04 - PRNHP05 - PRNHP06.
5.1
START UP
Park the appliance on an even surface. Insert the mains
plug into the socket.
Water supply
ATTENTION
Impurities in the water can damage the high-pressure pump
and the accessories.
Water supply from mains
Drawing in water from the open reservoirs
Screw the suction hose into the water connection of the
appliance and insert it into the water source (e.g. rainwater
drum).
Bleed the device as follows prior to operation:
• Turn on the appliance "OFF/ON" switch.
• Unlock the lever of the trigger gun.
• Push the lever of the trigger gun, the device will switch on.
• Let the device run (max. 2 minutes) until the water exits
the trigger gun without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
OPERATION
ATTENTION
Dry running of more than 2 minutes leads to damage of
the high-pressure pump. If the appliance does not build
up pressure within 2 minutes, switch the appliance off and
proceed in accordance with the instructions in Chapter
"Troubleshooting"
HIGH PRESSURE OPERATION
CAUTION
!
Keep a distance of at least 30 cm when using the
jet for cleaning painted surfaces to avoid damage.
CAUTION
!
Make sure the on/off switch is set to "OFF/O"
position and insert the plug into a properly installed
socket.
ATTENTION
• The washer must be used on a secure and stable surface
in a standing, upright position
Connect the product to power and water supply as
described.
• Open the water supply
• Hold the spray gun with both hands.
• Direct the nozzle of the chosen accessory away from you
towards the surface to be cleaned.
• Unlock the trigger and press it until a constant amount of
water flows through the nozzle, to allow air trapped in the
hose to escape.
• Release the trigger.
• Turn on the switch "OFF/ON".
• Hold the spray gun with both hands. Direct the water jet to
the object to be cleaned and press the trigger.
Release the lever of the trigger gun; the device will switch
off again and stop the water jet. High pressure remains in
the system.
WARNING!
Beware of kickback when pressing the trigger!