Nebula Capsule II Bedienungsanleitung Seite 7

Getting Started
Placement
Place this device on a stable. flat surface. and squarely
point it to face the projection surface. For best results. the
projection surface should be white and flat The distance
between this device and the projection surface must be a
minimum Of 23 inches (0.58 meters) and a maximum Of
121 inches (3.08 meters) to get a projection image from 20
to 1 00 inches.
It is unnecessaryto tilt it towards the projection
surface. You can correct the projection image with
the built-in keystone correction.
•Thedistance b etween thedevice a ndtheprojection:
surface determines the projection image size For
the best result, set the projector between 40 and
80 inches away
10
Prepare the Remote Control
2.
The remote control comes
O) For first time use, slide to open the battery
compartment, and install two AAA batteries.
To replacethe battery, unlock and open the battery
compartment, insert a new battery matching the
polarity (+/-) as indicated, and then close and lock the
battery compartment,
3. Get Started
(j)
Fully charge the built-in battery before using for the
first time by using the provided cable and charger.
HoldO on theprojectorfor 2secondsto turn it on.
Anglethe device towards a suitable projection surface or
wall.
To focus the image, slightly move the projector to
engage autofocus. Oryoucanpress andhold (9) for3
seconds to manually adjust the focus.
(5) For first time use, follow the on-screen
complete the basic setup,
-V-Togive yourNebula C apsule I Ithefastest, s afest
charge, use the supplied charger only
with two AAA batteries,
—usg-c
instructions to
11