Inserting/Replacing Batteries; Storage, Cleaning - Playtive Rc-11563 Bedienungsanleitung

• Do not mix different types and makes of bat-
teries and do not use new and used batteries
or batteries of different capacities together
since they can leak and cause damage.
• Observe the polarity (+/-) when installing.
• Replace all batteries together at the same time
and dispose of the old batteries in accord-
ance with the regulations.
• Warning! Batteries may not be charged or
reactivated by other means, nor may they be
disassembled, thrown onto a fire, or short-cir-
cuited.
• Always store batteries out of reach of children.
• Do not use any rechargeable batteries!
• Cleaning and user maintenance may not be
performed by children without supervision.
• When needed, clean the battery and device
terminals before inserting.
• Do not expose the batteries to extreme condi-
tions (e.g. radiators or direct sunlight). Other-
wise there is an increased risk of leakage.
• Warning. Used batteries must be disposed of
immediately. Keep new and used batteries out
of the reach of children. Seek medical help
immediately if you suspect that batteries have
been swallowed or ingested.
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it immediately as
per regulations. Wear gloves for this.
• If you come into contact with battery acid,
wash the affected area with soap and water.
If battery acid gets into your eye, rinse it
out with water and seek medical treatment
immediately!
• The terminals must not be short-circuited.

Inserting/replacing batteries

(figs. C and E)
WARNING! Comply with the following
instructions in order to prevent mechani-
cal and electrical damage.
For inserting and replacing the batteries (3)
proceed as shown in figs. C and E.
Note: You will need a suitable screwdriver (not
contained in delivery).
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
The batteries must be located entirely inside the
battery compartment.
Use
Switching the product on and off
(fig. B)
• To control the vehicle, flip the switch (1b) to
ON.
• When not using the vehicle, flip the switch
(1b) to OFF.
Vehicle control
To control the vehicle, hold the remote control
towards the vehicle after switching it on and
press the following buttons:
• Button (2a): Vehicle moves forwards (fig. F).
• Button (2b): Vehicle moves backwards (fig. G)
• Button (2c) in combination with button (2a):
Vehicle turns to the left (fig. H).
• Button (2d) in combination with button (2a):
Vehicle turns to the right (fig. I).
• Button (2c) in combination with button (2b):
Vehicle moves backwards turning to the left
(fig. J).
• Button (2d) in combination with button (2b):
Vehicle moves backwards turning to the right
(fig. K).
Trimming the front axle (fig. L)
If the vehicle no longer moves straight, even
though you are pressing button (2a), correct the
direction of travel. To do so, adjust the trimming
lever (1a) in the opposite direction.
Speed adjustment (fig. M)
Use the switch (1d) to set to one of the two
speed levels:
: Fast
: Slow

Storage, cleaning

When not in use, always store the product dry,
clean, without batteries, and at room temperature.
Wipe clean with a dry cloth only.
IMPORTANT! Never clean the product with
harsh cleaning agents.
GB 5