Repairs And Maintenance; Waste Disposal - Extol 8894003 Bersetzung Der Ursprünglichen Bedienungsanleitung

h) Handles and grip surfaces must be kept dry,
clean and free of grease. Slippery handles and
grip surfaces do not ensure a safe grip and control
over the power tool in unexpected situations.
5) SERVICE
a) The power tool must be repaired by a quali-
fied person that will use identical spare parts.
This will ensure that the same level of safety will be
achieved as before the repair of the power tool.
VIII. References to the
pictogram and label
Read the user's manual before use.
Corresponds to respective EU harmo-
nisation legal directives.
Protection class II.
When using the sander, use certified
eye and ear protection with a suffici-
ent level of protection.
When using the sander, use certified
respiratory tract protection with
a sufficient level of protection.
Electrical waste symbol. Do not
dispose of an unserviceable product in
household waste, but dispose of it in an
environmentally safe manner, see below.
Represents the year and month of
SN: manufacture and production batch
number
Table 3
EN
IX. Repairs
and maintenance
•
WARNING
y Carry out installation or maintenance/repair tasks on
the power tool with the el. power cord disconnected.
y Keep the power tool and its vents clean. Clogged vents
prevent air circulation, which may cause the motor to
overheat or a fire.
It is best to vacuum the dust from vents and the san-
ding base plate using a vacuum cleaner.
y The body of the power tool can be cleaned using
a damp cloth; prevent the ingression of water into the
power tool. Do not use any aggressive cleaning agents
and solvents. This would result in damage to the out
plastic cover of the tool.
INSPECTION/REPLACEMENT OF THE BRUSHES
y In the event that while the power tool is running, sparks
are evident inside of it or if it runs irregularly, have the
wear of the carbon brushes located inside the power tool
inspected at an authorised service centre for the Extol®
brand. The inspection and replacement may only be
performed by an authorised service centre for the Extol®
brand because it is necessary to work on the internal
parts of the power tool. You will find a list of service
centres at the website in the user's manual. The carbon
brushes must be replaced with original components.
SPARE PARTS AVAILABLE
FOR PURCHASE IF REQUIRED
Spare part Part number
Base 8894003B
Carbon brushes 8894003C
Table 4
 W hen the sanding base plate is replaced with a new
base plate, always attach it properly by firmly tigh-
tening all screws with washers.
y Original parts from the manufacturer must be used for
repairs of the power tool.
y For warranty repairs, please contact the vendor from
whom you purchased the product and they will organi-
se repairs at an authorised service centre for the Extol®
48
brand. For a post warranty repair, please contact the
authorised service centre of the Extol® brand directly
(you will find the repair locations at the website at the
start of this user's manual).
X. Storage
y Store the cleaned power tool in a safe location that
is out of reach of children where temperatures do
not exceed 45°. Protect the power tool against direct
sunlight, radiant heat sources, humidity and ingression
of water.
49
XI. Waste disposal
y Throw packaging into the appropriate sorted waste
container.
y According to Directive (EU) 2012/19,
unusable electrical equipment must not
be thrown out with communal waste since
it contains substances that are hazardous
to the environment, but rather must be
handed over for ecological disposal at an electrical
equipment waste collection point. You can find infor-
mation about electrical equipment collection points
and collection conditions at your local town council
office or at your vendor.
EN