MAINTENANCE
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent.
DO
NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Perimeter aspiration panel
Fig. 15
The panel for perimeter suction should always be left closed
and should only be opened in case of maintenance
interventions (eg cleaning or replacing filters).
Maintenance of the anti-grease filters
It absorbs unpleasant odors caused by cooking.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
CLEAN
WITH
TOOLS
OR
Maintenance of the charcoal filter
It absorbs unpleasant odors caused by cooking.
The charcoal filter can be washed every two months (or when
the filter saturation signal system - if present on your model -
shows such need) in hot water and suitable detergents or in
the dishwasher at 65°C (in this case run a complete wash
cycle with no dishes inside).
Remove excess water without damaging the filter and then put
the filter back in the oven for 10 minutes at 100°C to dry it
definitively.
Replace the pad every 3 years and every time the cloth is
damaged.
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
13