Whirlpool WEI9FFLRIX Betriebsanleitung Seite 12

CONTROLS
REMOTE CONTROL
The remote control must be recognized by the hood through the following procedure:
Hood and remote control pairing procedure
Press the "◄" or "►" button until the remote control shows the symbol
Press the middle button "■" for 5 seconds.
At this point, the pairing procedure is completed and the hood is configured to operate with the remote control.
N.B.: Pairing procedure can be done any time the hood is disconnected from and re-connected to the Mains within the first 60 secs.
Hob light ON/OFF:
Press the "◄" or "►" button until the remote control shows the symbol
Press the "+" button to switch the lights on.
Press the "-" button to switch the lights off.
Press the button "■" to change light status from off to on and vice versa.
Extraction power selection
:
Press the "◄" or "►" button until the remote control shows the symbol
Press the "+" button, "-" button or the button "■" respectively to increase, decrease or switch OFF (standby) the extraction power.
N.B.: during hood operation, the LED remains ON; it will switch OFF as soon as the motor status changes to OFF.
Filter RESET
The hood is fitted with a device indicating when filters maintenance needs to be done.
Grease filter saturation is indicated (while the hood is switched from OFF to ON) by means of the LED flashing (green).
Charcoal filter saturation is indicated (while the hood is switched from OFF to ON) by means of the LED flashing (red).
To reset the function:
While LED is flashing, press the "◄" or "►" button until the remote control shows the symbol
/
Press and hold the "■" button until LED stops flashing.
If both filter alarm are flashing, reset one and then the other.
Filter management
The grease filter alarm is always active.
The charcoal filter alarm MUST BE ACTIVATED at the first use.
To activate/disable the charcoal filter alarm:
Set hood to OFF.
Press the "◄" or "►" button until the remote control shows the symbol /
Press the "+" button for at least 5secs , led light aside hood flashes for 5secs to advice charcoal filter alarm si activated.
Press the "-" button for at least 5secs , led light aside hood switches ON for 5secs to advice charcoal filter alarm is disabled.
12