Changing The Oil - Ronix Rc-8010 Bedienungsanleitung

damage, weaken or destroy plastic which may result in serious personal
injury.
Electric tools used on fiberglass material, wallboard, speckling compounds,
or plaster are subject to accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not recommend using
this product for extended work on these types of materials.
However, if you do work with any of these materials, it is extremely
important to clean the product using compressed air.
BEARING LUBRICATION
All of the bearings in this product are lubricated with a sufficient amount
of high grade lubricant for the life of the unit under normal operating
conditions. Therefore, no further lubrication is required.
REPLAING THE AIR FILTER
1) Turn the air filter cover counterclockwise approximately one- quarter turn.
2) Remove the cover
3) Remove the air filter.
4) Install new air filter.
5) Replace the air filter cover and secure it by turning it clockwise.

CHANGING THE OIL

Replace the oil after the first 10 hours of operation and every 100 hours
following the oil change.
The sight glass, located above the tank, indicates the oil level and lets
the operator see at a glance if oil should be added.
1) Place as suitable container underneath the drain to collect used oil.
34
Air Compressor 80L