Ronix RC-8010 Bedienungsanleitung Seite 33

WARNING!
Air-powered tools may require more air consumption than this air
compressor is capable of providing. Check the tool manual to avoid
damage to the tool or risk of personal injury.
1) Control the amount of air flow with the pressure regulator knob. Turning
the knob fully counterclockwise will completely stop the flow of air.
NOTE:
Always use the minimum amount of pressure necessary for your
application. Using a higher pressure than needed will drain air from the
tank more rapidly and cause the unit to cycle on more frequently.
1) When finished, always drain the tank and unplug the unit. Never leave
the unit plugged in and/or running unattended.
2) Recommended for the use of a residual current device with a rated
residual current of 30mA or less.
DRAINING THE TANKS
To help prevent tank corrosion and keep moisture out of the air, used,
the air tanks of the compressor should be drained daily.
TO DRAIN
1) Turn the air compressor off.
2) Pull the ring on the pressure relief valve to release until pressure
gauge reads less than 1.4 bar.
3) Release the ring.
4) Rotate drain valves counterclockwise to open.
5) Tilt tank drain moisture tank into a suitable container.
31
User Manual