Using The Air Compressor - Ronix Rc-8010 Bedienungsanleitung

WARNING!
Always ensure the switch is in the OFF (O) position and the regulator
pressure gauge reads zero before changing air outlet. Failure to do so
could result in possible serious personal injury.

USING THE AIR COMPRESSOR

1) Ensure power switch is in OFF (O) position and air compressor is unplugged.
2) If not already installed, attach hose to compressor
3) Attach 6.35 mm (1/4 in.) NPT quick- connect air fitting to accessory
or tool you intend to use.
4) Insert the other end of the quick connect air fitting to the quick coupler
on the open end of hose.
5) Connect the power cord to the power supply.
6) Turn the switch ON (1).
7) Pull out and rotate pressure regulator knob to desired line pressure
at the outlet; turning counterclockwise regulator knob to desired line
pressure. Turning the knob clockwise increases air pressure at the
outlet; turning counterclockwise reduces air pressure at the outlet.
8) Following all safety precautions in the air tool manual. You may now
proceed to use your air-powered tool.
30
Air Compressor 80L