Ryobi RP4000 Bedienungsanleitung Seite 12

gB
FR DE ES
OPERATIOn
InSTALLIng/REMOVIng BATTERY PACK
See Figure 2
Pull and hold the height adjustment lever open to
■
release the inner console. Carefully remove the console
from its jacket.
nOTE: Always hold the unit upright to remove the inner
console. Opening the height adjustment lever while
turning the plumb/cross laser upside down could cause
the inner console to fall out.
Pull the tab on the battery cover to open the battery
■
compartment.
Insert the battery pack into the unit. Make sure the
■
raised rib on the battery pack aligns with the groove in
IT nL PT DK SE FI nO RU PL CZ HU
English
the compart-ment. Press down on the battery pack to be
sure contacts on the battery pack engage properly with
contacts in the compartment.
Close the battery cover and press the tab until it snaps
■
into place. Make sure it is securely fastened before
operating the plumb/cross laser.
nOTE: Do not attempt to operate the plumb/cross laser
if the battery compartment is not closed or is missing.
Holding the adjustment lever open, replace the inner
■
console into the jacket. Release the lever.
When transporting the plumb/cross laser, keep the inner
■
console fully seated in the outer jacket (locked position).
6
RO LV LT EE HR SI SK gR TR