Led Indicator Behavior; Connection; Functions Of The Buttons - Parkside Performance Pbl 40 A1 Bedienungs- Und Sicherheitshinweise

˜ LED indicator behavior
LED behavior table
Power
Status
ON/OFF
Power ON Power ON
Bluetooth

connection

TWS connection:
TWS
Pairing
mode:
TWS
Paired:
AUX
connection
Low battery LED flashes red once
Power OFF Power OFF OFF
˜ Establishing a Bluetooth
connection:
Remove all plugs from the AUX-in jack
o
before you attempt to establish a Bluetooth
connection .
Switch on the playback device and make sures
o
its Bluetooth mode is on .
®
On the product press the
o
[ 2 ]
LED flashes white per second and a signal
tone sequence sounds . The product will now
attempt to connect to the playback device (e .g .
smartphone or computer) .
The product identification on the playback
o
device will be "PBL 40 A1" . On the playback
LED indicator 2 ] [
color
LED flashes white once
per sec
Bluetooth Pairing
mode: LED flashes
white once per sec
Bluetooth Paired:
After Bluetooth pairing,
the LED turns solid
white
LED flashes blue once
per sec
After TWS pairing,
LED of primary unit
will flash blue and LED
of secondary unit will
have solid blue color
Solid green
per second
®
9 ] [
®
5 ] [
button until the
device "ACCEPT" the connection . Please
note the requirements of the software on the
playback device .
Once the connection is made the LED
o
flashes white turn solid white color .
The maximum range of the connection is
o
approx . 10 m, but this may be reduced due
to the geometry of the space (obstructing
furniture, walls, etc .) .
The playback device must support Bluetooth
o
standard 5 .3 otherwise you may not be able to
use all the functions .
˜ Functions of the buttons
Start a playlist on your playback device .
o
The product has 5 buttons and these control
o
the following functions:
Button Function
Press and hold approx . 2 seconds to
switch the product ON or OFF .
Press briefly to switch the source .
Press briefly during playback to pause
or continue playback .
In paired mode, press and hold
for approx . 2 seconds to change
to pairing mode to allow another
communication device to connect .
TWS mode:
– Double press to pair two speakers
(same model) before they connect
to an external Bluetooth playback
device . A signal tone will be heard
if pairing has been carried out
successfully . The two speakers now
work as stereo speakers .
– Double press again to break the
current TWS connection, a signal
tone will be heard .
[ 2 ]
®
GB/IE 31