Philips GC6360 Bedienungsanleitung Seite 13

Problem Cause
The soleplate is You may have ironed at a temperature
dirty. that is too high.
Impurities or chemicals present in the
water have deposited in the steam vents
and/or on the soleplate.
Dirty water Too much scale and minerals have
comes out of the accumulated inside the steam tank.
soleplate.
Steam escapes You may not have tightened the steam
from the filling tank cap properly or you have spilled
hole area during some water round the filling hole.
ironing.
Wet spots The wet spots that appear on your
appear on the garment after you have steam ironed for
garment during some time may be caused by steam that
ironing. has condensed onto the ironing board.
Iron the wet spots without steam for
some time to dry them. If the underside
of the ironing board is wet, wipe it with a
piece of dry cloth.
EnGlish
Solution
Clean the soleplate with a damp
cloth. Select the recommended
ironing temperature.
Clean the soleplate with a damp
cloth.
Rinse the steam tank. See chapter
'Cleaning and maintenance'.
Switch off the appliance and let it
cool down. Remove the steam
tank cap, wipe away the water
round the filling hole and tighten
the steam tank cap again. Then
switch the appliance back on.
To prevent steam from
condensing onto the ironing
board, use an ironing board with
a wire mesh top.
1