RONDELL RDE-1112 Bedienungsanleitung Seite 32

WARNING SIGNALS AND ICONS
When warning symbols/icons appear on the display,
follow the corresponding instructions on the display.
Troubleshooting
Malfunction Possible reason
The coffee machine does The unit is unplugged from the
not switch on mains
The unit is in the sleep mode
The coffee grinder is The coffee grinder is clogged
making odd noises
There are foreign objects caught
up in the coffee grinder
The coffee grinder The coffee grinder motor has
doesn't work broken
There are foreign objects caught
up in the coffee grinder
Liquid is slowly leaking The grind is too fine
from the coffee spout
The brewing unit is clogged up
Instead of coffee water Coffee beans are not sufficiently
drips from the coffee ground
supply block
Coffee beans are wet
The coffee machine The brewing unit has been insert-
displays a notification ed incorrectly
that there is no brewing
unit although it is installed
in the machine body
The coffee spout produc- The water supply system is
es too little coffee clogged with the residual scales
The milk is not frothing The milk frother is clogged
The milk frother is installed
incorrectly
The frothed milk control knob (15)
is set to the position «Hot milk»
This type of milk is not suitable
for frothing
Milk is not flowing into The milk system has been
the frothing and supply clogged
system
The milk supply tube is installed
improperly
Their purpose and interpretation are shown in the fig-
ures (Fig. 42-50).
Solution
Plug the coffee machine into the mains
Touch the ON button on the front panel
Clean the coffee grinder according to this guide
Unplug the coffee maker, remove foreign objects from
the coffee grinder and wipe it with a dry cloth.
Contact the service center
Unplug the coffee maker, remove foreign objects from
the coffee grinder and wipe it with a dry cloth.
Adjust the grinding by setting it to less fine grind
Clean the brewing unit following the guide
Adjust the coffee grinder settings to «+»
Replace the coffee beans with well-dried ones
Check the brewing unit and reinsert it in accordance
with this guide
Descale the coffee machine in accordance with this
guide
Fully clean the milk system and milk tube.
Check the milk frother and reinstall it in accordance
with this manual
Turn the control knob (15) counterclockwise to the
position «Frothed milk»
For best results, use whole milk
Perform the complete cleaning of the milk system,
according to this manual
Recheck the installation of the milk supply tube, it
should be located below the upper edge of the milk in
the container
32