Cleaning And Maintenance - Rondell Rde-1112 Bedienungsanleitung

mode, semi-economy mode or in normal mode. When
the full brightness is selected, the display lights up con-
stantly. If you select the semi–economy mode after 1
minute of waiting, the brightness of the display of the
coffee machine will be reduced; if you select the econ-
omy mode, after 1 minute of waiting, the display will be
completely darkened. When you press any of the but-
tons on the control panel, the readings on the display
will appear with standard brightness.
The mode is selected by sequentially pressing the «Con-
troller» button (29). To set the selected value, press the
«Ground coffee/Input» button (28), to exit the timer
settings menu, press the «On/Off/Exit» button (16).
LANGUAGE
The setting allows you to change the information dis-
play language on the display (18). Press the «Ground
coffee/Input» button (28).
To change the parameter, use the «Controller» but-
ton. To remember the selected parameter, press the
«Ground coffee/Input» button (28), to exit the timer
settings menu, press the «On/Off/Exit» button (16).
COUNTER
The «COUNTER» mode displays the number of pre-
pared drinks. Control of the amount of prepared
drinks is necessary for timely decalcification of the
coffee machine. See the section Descaling (de-
calcification).
Press the «Ground coffee/Input» button (28) to view
the number of different drinks that have been prepared
in your coffee machine. Prepared drinks are displayed
in sequence: Americano/Espresso/Cappuccino/Latte
(Fig. 27).
To exit the counter menu, press the «On/Off/Exit» but-
ton (16).
CALIBRATION
This mode is intended for technical specialists of ser-
vice centers.
Drip Tray (1)
When the level of the drained liquid rises to the upper
limit, the float water level indicator rises, after which it is
required to drain the liquid from the drip tray.
Brewing unit (12)
Please do not open the door (11) or move the brewing
unit (12) during coffee making. If the display (18) shows
«Install the brewing unit» (Fig. 28), please take it out and
then re-insert it until it stops and clicks.

CLEANING AND MAINTENANCE

Washing the milk supply system
After each drink with milk, it is necessary to clean the
coffee machine from its residues.
– Install the container for draining the liquid under the
coffee supply unit (2) of the coffee machine and
adjust its height (Fig. 5).
– Place the milk (31) supply tube on the coffee spout
(3) and adjust its height (Fig. 5).
– Put the tube in a container with clean water (Fig. 14).
– Press the «Milk» button (21).
– Repeat the procedure until the milk tube becomes
completely clean
– Drain the liquid from the tray (1).
Notes: We recommend washing the milk system after
each use.
ATTENTION! During the cleaning process, do not touch
the coffee supply unit (2) to avoid burns.
Flushing the milk frother
1. Press the locks of the milk frother (30) (Fig. 29) and
remove it from the coffee supply unit (2).
2. Put the frother into a container with warm clean water
for a while, then rinse it and dry it.
3. Put the milk frother back into the coffee machine
(Fig. 18).
Cleaning the coffee bean container
– Disconnect the unit from the mains.
– Open the coffee bean container lid (8) and clean the
inside of the coffee bean container (10) with a dry
soft cloth.
ATTENTION! Do not use water or sharp objects to clean
the container (10).
Cleaning the brewing unit
Note: We recommend cleaning the brewing unit once
a month.
30