Crivit FM-7091 Gebrauchsanweisung Seite 5

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following instructions for
use carefully.
Use the product only as described and only
for the given areas of application. Store these
instructions for use carefully. When passing the
product on to third parties, please also hand
over all accompanying documents.
Scope of delivery (fig. A)
1 x stand with support feet (1)
1 x bicycle mount (2)
1 x telescopic rod (3)
1 x front wheel stabiliser (4)
2 x rubber connection (5)
1 x tool tray (6)
1 x clamp (7)
2 x screw (8)
1 x allen key (9)
1 x instructions for use
1 x quick guide
Technical data
Maximum load capacity: 30kg
For bicycle frames: Ø of approx. 25mm – 55mm
Date of manufacture (month/year):
10/2022
Intended use
This bicycle repair stand has been developed for
private use. It allows bicycles to be suspended
and clamped so that repairs can be performed.
Ensure that the floor
is level and position
is stable.
Safety instructions
Risk of injury!
• Read through the instructions for use before
assembly and follow the steps one by one as
described in the instructions.
• WARNING! Do not exceed the maximum
load capacity of 30kg!
• There is risk of injury and of damage to the
product.
• Check all parts of the product regularly. Loose
screws must be tightened and defective parts
replaced in order to avoid damage to the
product.
• Make sure that the socket screws on the upper
tube connector always remain tight.
• WARNING! Set the product up only on a
firm and even surface to prevent the product
from falling over.
• WARNING! No one must sit on the bicycle
once clamped. There is risk of injury
• WARNING! Any use other than for the
intended purpose or any improper use can
lead to endangerment of persons or damage
to the bicycle.
• Avoid any aggressive chemical substances
(e.g. solvents)!
• Discontinue use if damaged.
• When using the product always adhere to
the operating instructions of the pedelec or
bicycle manufacturer.
• Check the product for damage and wear be-
fore each use. The product may only be used
in good order and condition!
Caution! Risk of trapping fingers!
• When unfolding and folding up the repair
stand be sure not to trap your fingers.
• Position the repair stand so that you have
enough space for movement, including when
the bicycle is set up.
Avoiding material damage!
• To prevent damage to the bicycle be careful
not to trap any parts or cabling in the repair
stand.
• Carbon frames and other bicycle frames with
thin walls are extremely sensitive to pressure!
Use appropriate clamping force of the clamp
so as not to damage the frame.
GB/IE/NI 7