Silvercrest SWP 8.5 A1 Bedienungs- Und Sicherheitshinweise Seite 15

˜ Replacing the
battery (see fig. A)
CAUTION! Use the above-
m
indicated battery types only.
Failure to observe this advice
may result in damage to the
product.
Open the battery compartment
o
by turning the battery
6 ] [
compartment screw
anticlockwise with a small
screwdriver then pull out the
battery compartment cover
compartment.
Replace with a new 3 V
o
type CR2032 battery.
The marking "+" must face
upwards.
Place back the battery
o
compartment cover
close the battery compartment
and tighten it by turning
6 ] [
the battery compartment screw
clockwise with a small
5 ] [
screwdriver.
˜ Operation
Remove the stylus pen
o
the top middle (model A: from
the bottom) of the writing pad.
Write what you want directly
o
on the LCD screen
stylus pen
2 ] [
[ 5 ]
7 ] [
to
7 ] [
from
2 ] [
with the
1 ] [
.
Note: Please do not write on the
LCD screen . In the worst case,
[ 1 ]
sharp objects can irreparably
damage the LCD writing board.
When you want to rewrite
o
on the writing pad , press
the erase button
the content. Ensure that the
screen lock
3 ] [
position .
The screen lock
o
to lock the erase button
prevent losing content while
you are writing or drawing.
After locking
button , you can still write
[ 4 ]
on the writing pad.
˜ Troubleshooting
If the erase button
function , please ensure that the
screen lock is in the unlock
[ 3 ]
position. If the writing pad does
not function replace the battery
as described in the "replacing the
battery" section.
˜ Cleaning and
maintenance
Under no circumstances should
o
you use liquids or detergents,
as these will damage the
product.
to clear
4 ] [
is in the unlock
function is
3 ] [
to
4 ] [
the erase
does not
4 ] [
GB 13