Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The router bits should be clamped all the way to the marked point on
the shank (Fig . C) .
Care shall be taken of router bits to ensure that the clamping is by the
shank of the tool and that the cutting edges are not in contact with each
other or with the clamping elements .
Fastening screws and nuts should be tightened using the appropriate
spanners, etc . provided by the manufacturer .
Extension of the spanner or tightening using hammer blows is not
permitted .
Clamping surfaces should be cleaned to remove dirt, grease, oil and
water .
Clamping screws must be tightened according to instructions .
2 hex keys (2 .0 mm/2 .5 mm) and 3 spare ball bearings (small/
medium/large) are included in the scope of delivery .
˜ Cleaning and care
˜ Cleaning
Router bits should be cleaned regularly .
Remove the bearing .
Clean the router bits with lubricating oil .
Tighten and lubricate the bearing .
˜ Maintenance of router bits
Repair or regrinding of the router bits is not permitted .
Dull or damaged router bits must not be used .
When the bearing of the router bits does not roll smoothly, replace it as
follows:
1 . Use the included hex key to loosen the cap screw .
2 . Remove the ball bearing .
3 . Install a suitable spare ball bearing .
4 . Tighten the cap screw .
8
GB
Werbung
