Use; Start-Up And Starting The Cycle; Adjustments During Use; Tool Change - Femi Job Line DP 12-941 PLUS Bedienungsanleitung

9. Use

PPE REQUIRED

9.1. Start-up and starting the cycle

1. Press the ON button.

9.2. Adjustments during use

9.2.1.

Tool change

1. Before accessing the chuck, open the front
protection door.
For a keyed chuck:
For a keyless chuck:
2. Make sure the drill bit is centred in the chuck.
Tighten the bit sufficiently so that it does not
slip while drilling.
INSTRUCTION MANUAL - TRANSLATION OF THE ORIGINAL INSTRUCTIONS
9.2.2.

Drilling speed adjustment

IMPORTANT! Use the recommended
speed for the bit you are using and
for the material to be drilled.
DP 12-941 PLUS
The chuck of this drill can turn at 12 different
speeds: from 230 to 2470 rpm.
DP 12-951 PLUS
The chuck of this drill can turn at 12 different
speeds: from 180 to 2740 rpm.
English ▪ 23